Transformer (T1) Low-Voltage Secondary Winding; Filament Winding) Test - Miele M 6160 TC Manual

DTD no. 24-6160
4.30 Transformer (T1) Low-Voltage Secondary Winding (Heater

Filament Winding) Test

A Removing the Microwave Oven from a Housing Unit, 001 4.4.
A Cover Removal, 001 4.5.
Danger!
For safety reasons, it is important to ensure that the high-voltage capacitor is
discharged by always short-circuiting it before starting any maintenance or
repair work. See .
A Disconnect both magnetron connections.
A Use an ohmmeter (in accordance with IEC 61010-1) to measure the
resistance between the two connections. The ohmmeter must be able to
measure in the m range.
A The measured resistance must be < 1 .
Danger!
In order to ensure that no microwave energy can escape after any repair work
has been completed, the microwave oven must be thoroughly checked for
microwave leaks using a suitable microwave leak detector (mat. no. 05595470).
Particular care should be taken around the door and the casing edges.
The maximum permissible value is 5mW/cm
measured at a distance of 5cm (2 inches) from the oven with a water load of
3
275cm ±15cm
01.10.2014, US_am
3
(0.073 gallons ± 0.004 gallons).
This information should not be duplicated or passed on without Miele approval. All rights reserved.
Descriptive Technical Documentation
2
(32.3mW per square inch),
001-53