Uhf Setting - KoamTac KDC480 QG Quick Manual

9.9 UHF Setting

Change the connected KDC UHF configurations.
1. Enable UHF Power
Determine whether UHF Power is on or off.
2. UHF Power Level
Set UHF Power Level to the specific dBm.
3. Enable Smart Hopping
Enable or Disable "Smart Hopping" function.
It is depended on KDC which you are using.
4. UHF Read Tag Mode
Select UHF Read Tag Mode.
Single – Read only one tag.
Multiple – Read tags for a specific time.
Active – Read tags during "Scan" button is pressed
5. UHF Reading Timeout
Set Reading Timeout for Multiple Read Tag Mode.
6. Enable Duplicate Check
If enabled, duplicated tag data is not sent by KDC.
7. UHF Read Mode
Determine whether to scan Barcode or UHF when a Scan button of KDC is pressed or a scan
command is received from the application.
8. UHF Data Type
Select UHF Data Type. Received data is composed with EPC and PC or EPC only.
9. Set UHF Region
Set UHF bandwidth (Frequency, Power, ...) to fit the region.
It is depended on KDC which you are using.
10. Stop Active Read
"Active Read" function stops after a certain period of time.
11. RFID beep count
Select read beep count of KDC.
See Reference Manual for more detailed information.
Visit store.koamtac.com to purchase additional KDCs and accessories.
KDC480/485 QG
Quick Guide
QG_KDC480/485_20220630 p30