Mitsubishi DiamondPoint NXM76LCD User Manual page 11

Controls
AccuColor ®
AccuColor
(sRGB and NATIVE color presets are standard and cannot be changed).
R,G,B: Increases or decreases Red, Green or Blue color depending upon which
is selected. The change in color will appear on screen and the direction
(increase or decrease) will be shown by the bars.
NATIVE: Original color presented by the LCD panel that is unadjustable.
sRGB: sRGB mode dramatically improves the color fidelity in the desktop
environment by a single standard RGB color space. With this color supported
environment, the operator could easily and confidently communicate color
without further color management overhead in the most common situations.
Tools
LANGUAGE: OSD control menus are available in seven languages.
OSD Position: You can choose where you would like the OSD control
image to appear on your screen. Selecting OSD Location allows you to
manually adjust the position of the OSD control menu left, right, down or up.
OSD TURN OFF: The OSD control menu will stay on as long as it is in use. In
the OSD Turn Off submenu, you can select how long the monitor waits after
the last touch of a button to shut off the OSD control menu. The preset choices
are 10, 20, 30, 45, 60 and 120 seconds.
OSD LOCK OUT: This control completely locks out access to all OSD control
functions without Mute, Sound Volume, Brightness and Contrast. When
attempting to activate OSD controls while in the Lock Out mode, a screen will
appear indicating the OSD controls are locked out. To activate the OSD Lock
Out function, press SELECT, then "+" key and hold down simultaneously. To
de-activate the OSD Lock Out, press SELECT, then "+" key and hold down
simultaneously.
RESOLUTION NOTIFIER (NXM56LCD): This optimal resolution is 1024 x 768.
If ON is selected, a message will appear on the screen after 30 seconds,
notifying you that the resolution is not at 1024 x 768.
RESOLUTION NOTIFIER (NXM76LCD): This optimal resolution is 1280 x 1024.
If ON is selected, a message will appear on the screen after 30 seconds,
notifying you that the resolution is not at 1280 x 1024.
HOT KEY: You can adjust the sound volume and brightness directly. When
this function is set to ON, you can adjust the sound volume with + or –,
brightness with < or > key, while the OSD menu is off.
OFF TIMER: Monitor will automatically power-down when the end user has
selected a pre-determined amount of time.
FACTORY PRESET: Selecting Factory Preset allows you to reset all OSD control
settings back to the factory settings. The RESET button will need to be held
down for several seconds to take effect. Individual settings can be reset by
highlighting the control to be reset and pressing the RESET button.
NXMLCD122702.p65
–continued
Control Systems
Control Systems: Six color presets select the desired color setting
®
9
9 12/27/02, 3:32 PM