Single-Zone System Wiring Example; Wireless Remote Mounting Considerations; Mounting The Wireless Remote - Garmin TREAD XL BAJA CHASE EDITION Owner's Manual

Single-Zone System Wiring Example

Speakers
Water-tight connection

Wireless Remote Mounting Considerations

Selecting the correct mounting location is critical to optimize the performance of the wireless remote.
• You must mount the wireless remote in a location that is within 10 m (33 ft.) of the stereo.
• You must mount the wireless remote in a location where it is not submerged.
• You should select a flat mounting surface for the best results.
• The mounting surface must be free of dirt, debris, wax, or coatings.
• Move away from sources that can interfere with the wireless remote's operation. Sources of interference
may include strong electromagnetic fields, some 2.4 GHz wireless sensors, high-voltage power lines, electric
motors, and wireless LAN access points.
• You should install the wireless remote in a location where you can allow the adhesive to dry at room
temperature for 72 hours.

Mounting the Wireless Remote

1 Select an appropriate location for the remote control
2 Test the range at the selected location by holding the wireless remote at the location, pressing a few buttons,
and confirming the correct operation.
3 Thoroughly clean and dry the mounting surface using a mixture of water and isopropyl alcohol.
The mounting surface must be free of dirt, debris, wax, or coatings.
4 Place the wireless remote on the mount, and rotate the remote until you hear a click.
5 Remove the backing from the adhesive.
6 Carefully orient the wireless remote in the mount with the Fusion
It is extremely difficult to remove the adhesive. Some mounting surfaces might be damaged after removing the
adhesive.
7 Press the wireless remote in the mount firmly onto the mounting surface, maintaining pressure for at least
60 seconds.
Appendix
NOTICE
(Wireless Remote Mounting Considerations,
® logo at the bottom.
NOTICE
page 71).
71