Mounting The Speakers And Brackets - Garmin TREAD XL BAJA CHASE EDITION Owner's Manual

Mounting the Speakers and Brackets

You can mount the Tread 6.5" XS-LED Tower Speakers to a roll bar using the included brackets.
When installing the speaker and bracket, you can route the speaker and LED cable along the roll bar.
1 If necessary, mark the locations on the roll bar where you plan to mount the speakers.
2 Route the speaker and LED power wires along the roll bar to the mounting locations.
3 Feed the cable from the speaker through the base of the bracket
4 Place the base of the bracket over the mounting knob on the speaker
5 Using a 4 mm hex driver or hex key, attach the collar
screws and washers
6 Connect the speaker and LED wires
7 Place the connected wires in the channel on the base of the bracket
bar.
8 Place the top of the bracket
9 Using a 5 mm hex driver or hex key, attach the top of the bracket to the base of the bracket using the two
longer screws and washers
72
, but do not fully tighten them.
(Wiring, page 73).
over the roll bar, and hold it against the base of the bracket.
, but do not fully tighten them.
.
.
to the base of the bracket using the two shorter
, and route the wires along the roll
Appendix