Table of Contents
Advertisement
Safety Information
The Agilent U1731A and U1732A are safety-certified in
c o m p l i a n c e w i t h t h e f o l l o w i n g s a f e t y a n d E M C
requirements:
• IEC 61010-1:2001/EN 61010-1:2001 (2nd Edition)
• CISPR 11:2003+A1:2004
• IEC 61000-4-2:1995+A1:1998 +A2:2000
• IEC 61000-4-3:2006
• IEC 61000-4-4:2004
• IEC 61000-4-5:2005
• IEC 61000-4-6:2003+A1:2004+A2:2006
• IEC 61000-4-11:2004
• Canada: ICES-001:2004
• Australia/New Zealand: AS/NZS CISPR11:2004
Safety Notices
C A U T I O N
A CAUTION notice denotes a hazard. It calls attention to an
operating procedure, practice, or the like that, if not correctly
performed or adhered to, could result in damage to the
product or loss of important data. Do not proceed beyond a
CAUTION notice until the indicated conditions are fully
understood and met.
WA R N I N G
WARNING notice denotes a hazard. It calls attention to an
operating procedure, practice, or the like that, if not cor-
rectly performed or adhered to, could result in personal
injury or death. Do not proceed beyond a WARNING notice
until the indicated conditions are fully understood and met.
1
Safety Symbols
Direct current
Alternating current
Three-phase alternating current
Both direct and alternating current
Earth (ground) terminal
Equipotentiality
Caution: hot surface
Off (supply)
On (supply)
Protective conductor terminal
Caution: risk of electric shock
Out position of a bi-stable control
In position of a bi-stable control
Frame or chassis terminal
Equipment protected throughout by
double insulation or reinforced
insulation
Caution: risk of danger (refer to this
manual for specific Warning or Caution
information)
U1731A/U1732A Quick Start Guide
Advertisement
Table of Contents
