Troubleshooting; Error Codes And Messages; Internal Device Error Codes; Table 9 - Internal Error Codes - DCS 992 User Manual

dCS 992 User Manual
dCS Ltd
T
ROUBLESHOOTING

Error Codes and Messages

Internal Device Error Codes

Manual part no: DOC063992 iss 2A1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
The error codes reported by dCS 992 provide an effective means to diagnose the
majority of problems that may be encountered in use - including problems with
the overall system the unit operates in, internal device warnings and internal
device failures. Please note that through damage or component failure, the unit
self check may fail to operate. If this happens, please contact your Distributor or
dCS for assistance.
Sometimes the unit may misbehave. If there is an internal reason, an internal
device error code may be displayed as follows:
Err.xy
an error xy (see table below) has been detected.
xy
where values have the following meanings:
Code Description
2
01 E memory (EEPROM) not present
02 Error initialising DSP
03 Error loading DSP
04 Error initialising DSP for coefficients
05 Error initialising DSP for coefficients
06 Error loading DSP coefficients
07 Error loading DSP coefficients
08 Error sending command
09 Error sending command
10 Error sending command
11 Error sending command
12 Error with LSB/MSB configuration
13 Error with LSB/MSB configuration
14 Error with LSB/MSB configuration
15 Error configuring FPGA
99 DSP error
If you get any of these, please contact dCS, with as much information as
possible to help us re-create the problem. Some of these may have hardware
problems as their cause, some may be caused by software problems.
Manual for Software Version 2.0x
Table 9 – Internal Error Codes
Page 64
January 2001
file 063992ma2a1.pdf available from website
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk