DCS 992 User Manual page 29

dCS 992 User Manual
dCS Ltd
Manual part no: DOC063992 iss 2A1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
In this case, this output has "Link to AGEN 1" selected, which means that this
SGEN generator will track the frequency output by the AGEN 1 generator (which
might NOT be coming out of the
only the phase of the generator, and not the frequency, can be adjusted. Every
time the AGEN 1 generator changes frequency, this output will follow it. If you
uncheck this box, then the frequency list becomes available.
SGENs can also generate "superclocks", which are multiples of standard clock
rates. These are slightly different from standard wordclock outputs as follows:
•
Superclocks only run at a multiple of the AGEN 1 generator frequency. For
example, if AGEN 1 is a 48k based frequency, available superclock outputs
are 192kHz, 384kHz, 768kHz, 1.536MHz, 3.072MHz, 6.144MHz and
12.288MHz. A 256 Fs superclock, as used by some manufacturers, would
be 12.288MHz
•
Superclocks cannot have their phase altered
The following dialog shows the frequency list with available superclocks, with
AES1 generator set to be 44.1k.
The Clock Phase offset slider, OK, Cancel and Apply buttons behave in the
same way as for the AES generators.
Manual for Software Version 2.0x
AES 1 output). Linking to AGEN 1 means that
Page 29
January 2001
file 063992ma2a1.pdf available from website
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk