Menu Items - DCS 992 User Manual

dCS 992 User Manual
dCS Ltd

Menu Items

Issue
– Software Issue
Offst
– VCXO Frequency Trim
Read
– Setup Unit from a Store
Manual part no: DOC063992 iss 2A1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
Displays the software issue when Menu
Trims the appropriate TCXO frequency in master mode, by up to ±5ppm in
0.05ppm steps. Press the
increase the value. The Offset for both VCXO's is remembered.
Reads back the content of a store, and sets the unit up accordingly. There are
nine user programmable stores
A-E). The dCS pre-loaded stores may not be overwritten – the user
(Stores
stores may be loaded by the user when setting up the unit with the remote from
a PC. Note that there is no facility to load the stores without using a PC – the
possibility of an eroneous setup is too high.
Stores A B
or may be regarded as a factory reset – they set the unit up for
straight forward 44.1kS/s or 48kS/s operation. Press menu
through the stores (1-9, then A-E) then
The intended mode of use is that the unit be set up using the Remote software
running on a PC, and then the setup stored. The unit can then recall the setup
either in the studio or on location – even if it is complex. This way, set ups only
have to be worked out once.
Stores A-E
The contents of
x
Set is pressed.
x
Down button to reduce the value or the
x
1-9) and five dCS pre-loaded stores
(Stores
Set to select one.
is pre-loaded as in
Page 20
Manual for Software Version 2.0x
January 2001
Up
Step
Table 3 below.
file 063992ma2a1.pdf available from website
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk
button to
to scroll