Table of Contents
Advertisement
I.
Safety Information
Do not operate the unit if the casing or the test Leads are or
look damaged.
Check the main function dial to ensure it is set at the
correct position before each measurement.
Do not perform resistance and continuity test on a live
"powered "system.
Do not apply voltage between the test terminals and test
terminal to ground that exceed the maximum limit referred
to in this manual.
Exercise extreme caution when measuring live systems
with voltage greater than 60V DC or 30V AC.
Keep fingers behind the protection ring when measuring
with test leads.
Replace batteries when the
incorrect data.
Environmental Conditions:
Altitude up to 2000 meters.
Operating temperature: 0°C ~ 40°C, <80% RH, non-condensing
Storage temperature: -10°C ~ 60°C, <70% RH, battery removed
Pollution Degree: 2
Explanation of Symbols:
Attention refer to operation Instructions.
Dangerous voltage may be present at terminals.
This instrument has double insulation.
Approvals:
symbol appears to avoid
EN61010 600V CAT II 300V CAT III
1
Instruction Manual
Advertisement
Table of Contents
