Table of Contents
Advertisement
6 Instruction of operation
After correct installation, the device can be operated by touch screen, operation
procedure as follows:
In above operation procedure flow chart, "Product parameter" should be added
before any new product needed to be checked. "Calibration" should be carried out
when the device is installed the first time.
Daily operation
Switch on device
Prerequisites:
- The device has been installed properly and all wires have been connected correctly.
- The operating conditions listed in 2.4 have been fulfilled.
- The operator has been trained and operation procedure must comply with the safety
instructions listed in chapter 3.
- The weighing belt is empty.
Switch on the device at least 20 minutes before start weight
checking.
The pre-run aims to ensure the system reach the correct operating
temperature. Ignore the pre-run may cause negative effect on the
precision of the weighing result.
Power
Logon
Calibration
PD parameter
Start
Data
Stop
Fig 6-1 Operation procedure of Checkweigher
Checkweigher user's manual
Technician
Product
12
Advertisement
Table of Contents
Need help?
Do you have a question about the Checkweigher and is the answer not in the manual?
Questions and answers