Transmitter Event Notification Settings; Set Transmitter Notify Flags Via Nus, Uart; Read Transmitter Notify Flags Via Nus, Uart; Set Transmitter Notify Flags Via Configuration Service - Globalstar ST150M User Manual

9150-0125-01 R-1
Main features:
1. All URC Notification settings will have distinct AT command to configure each component over UART and Nordic UART
Service (NUS) with supported notification flags.
2. AT command to configure URC Notification settings of each component over Config Service (NUS) will have distinct AT
command with same notification flags supported over UART & NUS interface settings.
3. Each event type associated with each component will have corresponding notification flags code to enable notification to
capture URC's messages on event generation.
4. To enable multiple events notification of a component the addition of all notification flags code assigned is a valid Notify flags.
5. If trying to enable an un-supported notifications flag will return an INVALID PARAMS error code.

7.2.1 TRANSMITTER EVENT NOTIFICATION SETTINGS

Supported Transmitter Event notifications code <transmitterNotifyFlags>:
• TRANSMITTER_NOTIFY_FAULT_DETECTED = 1
• TRANSMITTER_NOTIFY_ACTIVATED = 2
• TRANSMITTER_NOTIFY_DEACTIVATED = 4
• TRANSMITTER_NOTIFY_RAS_DETECTED = 8
• TRANSMITTER_NOTIFY_RAS_CLEARED = 16
• TRANSMITTER_NOTIFY_TEMP_THRESHOLD_DETECTED = 32
• TRANSMITTER_NOTIFY_TEMP_THRESHOLD_CLEARED = 64
• TRANSMITTER_NOTIFY_TEMP_UNDER_THRESHOLD_DETECTED = 128
• TRANSMITTER_NOTIFY_TEMP_UNDER_THRESHOLD_CLEARED = 256
• TRANSMITTER_NOTIFY_TEMP_PWR_EXCP_DETECTED = 512
• TRANSMITTER_NOTIFY_TEMP_PWR_EXCP_CLEARED = 1024

7.2.2 SET TRANSMITTER NOTIFY FLAGS VIA NUS, UART.

AT+TXNSF =<transmitterNotifyFlags>

7.2.3 READ TRANSMITTER NOTIFY FLAGS VIA NUS, UART.

AT+TXNSF?

7.2.4 SET TRANSMITTER NOTIFY FLAGS VIA CONFIGURATION SERVICE

AT+TAXNSF =<transmitterNotifyFlags>

7.2.5 READ TRANSMITTER NOTIFY FLAGS VIA CONFIGURATION SERVICE

AT+TAXNSF?
Example:
• To receive Transmitter Activation and Temperature detected event notification, the valid command to activate notification
AT+TXNSF = 34.
• To receive all Transmitter event notifications, the valid command to activate all notifications AT+TXNSF = 2047.
• AT+TXNSF = 2048 will return ERROR.

7.3 MESSAGE QUEUE EVENT NOTIFICATION SETTINGS

Supported Transmitter Event notifications code <messageQueueNotifyFlags>
ST150M User Manual Confidential & Proprietary Information 30