Installation Of The Shifting Cable - Shimano NEXUS SG-C7002-5 Dealer's Manual

Installation/removal

Installation of the shifting cable

Installation of the shifting cable
Shift lever side
1. Install the inner cable and outer casing aligned with the shift lever.
Refer to the dealer's manual of the shift lever for details.
Make sure that the sealed outer cap is at the shift lever end.
Shift lever side
Sealed outer cap
Cassette joint side
1. Operate the shift lever and set to the specified gear position.
SG-S7001 (internal 11-speed): 11-speed
SG-S7001 (internal 8-speed): 8-speed
SG-C6001 / SG-C6011 (internal 8-speed): 1-speed
SG-C7000 / SG-C7002 (internal 5-speed): 5-speed
2. Install the rubber cover and rubber bellows to the outer casing holder body.
Rubber bellows
This operation is not required if there is no rubber cover or rubber bellows.
Cassette joint side
Outer casing holder
body
Rubber cover
29