Assembling The Bagger - Toro 79161 Operator's Manual

1
3
2
Figure 10
1. Idler pulley bracket and
pulley
2. Top side of belt against
bottom pulley
6. With the belt installed, swing the blower toward the
mower until the blower latch locks over the pin at the
back of the mower (Fig. 11).
Important You may have to lift the blower slightly for
the latch to close. Make certain that the latch operates
smoothly and closes completely.
Figure 11
1. Blower latch
7. Install the blower belt cover using 4 washers and 2
locknuts (5/16 in.) (Fig. 12).
m–3557
3. V-side of belt into top
pulley
1
2
m–3594
2. Pin
1
2
Figure 12
1. Mower belt cover
2. Washer
Installing the Leveling Brackets
1. Replace the left side mower leveling bracket (slotted)
with a new leveling bracket (hole) (Fig. 13). Secure it
with the existing washers and hairpin cotters (Fig. 13).
Note: Save the slotted leveling bracket for future side
discharge operation.
Figure 13
1. Slotted leveling bracket
2. Check the mower level front-to-rear and side-to-side;
refer to Tractor Operator's Manual for instructions.

Assembling the Bagger

1. Install the full-bag indicator rod through the hole in the
rubber seal and the slot in the bagger cover (Fig. 14).
Mount the full-bag indicator rod against the bagger
cover using two clips, screws (1/4 x 3/4 in.), and
locknuts (1/4 in.) (Fig. 14).
9
3
2
m–4840
3. Locknut, 5/16 in.
1
2
m–5177
2. Washer and hairpin cotter