Page 1
FORM NO. 3322–658 INSTALLATION Model No. 79174 INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Kicker Carriage bolt 5/16–18 x 3/4” (19mm) Install kickers Spacer Locknut 5/16” (7.9 mm) High–lift blade Replace standard blades on mower...
Page 2
Installation Installing the Kickers Installing the High-lift Blades Place spacers and kickers inside the mower, over the Remove standard blades (Fig. 2). holes provided (Fig. 1). Remove any hardware Holding the blade end using a rag or thickly installed in these holes and save for reinstallation if padded glove, install each high–lift blade, the kickers are removed.
Page 3
Installation Installing Recycler Decal Installing the Recycler Baffles Remove backing paper and apply decal to left Place the left side baffle inside the cutting side of mower (Fig. 4). Smooth from center to chamber. Secure it with (2) 5/16” locknuts and (2) Bellville washers (Fig.
Page 4
Installation Removing the Right Baffle for Side Discharge Cutting Thoroughly clean the mower. Remove the locknuts and Bellville washers from the right side baffle (Fig. 5). Note: Only the right side baffle needs to be removed for side discharge mowing. Note: Save the hardware for use when reinstalling the baffle.