Connecting The Scanner To Your Computer; Using The Firewire Cable - Microtek ArtixScan 1800f Installation And Operation Manual

Connecting the Scanner to Your Computer

The ArtixScan 1800f comes with both FireWire and USB 2.0 built-in interfaces. You
may choose either FireWire (IEEE-1394) or USB 2.0 as the interface for connection
between the scanner and computer. (You can use only one interface at a time.)

Using the FireWire Cable

Before connecting the scanner, check to see if your computer system is FireWire-
ready (i.e., your scanner can be connected to the computer using the FireWire cable
provided.)
System is FireWire-ready
• For Macintosh users, your computer should have been equipped with a built-in
FireWire port. This port should be designated with the FireWire symbol "
shown to the left.
• For PC users, the FireWire card should be installed and should work properly in
your computer.
System is Not FireWire-ready
If your system is not FireWire-ready, you will need to install a FireWire card. For more
details on how to install the FireWire card, please refer to the separate documentation
included with your scanner package. Alternatively, you can use the USB 2.0 interface
to connect your scanner.
For FireWire-ready Systems:
1. Connect the power cord to your scanner.
Plug the power cord into the back of the scanner, and plug the other end into a
power source (power surge protector highly recommended). Make sure no other
cable is connected to the scanner except the power cord at this point.
ArtixScan 1800f Installation and Operation Manual
"
7