Table of Contents
Advertisement
E. Resist quantity adjustment
This adjustment is performed in the following cases:
•When the void quantity is changed by the paper feed tray.
•When paper feed skew occurs.
Before executing this adjustment, the following adjustments must have
been completed.
•LSU right-angle adjustment
•Print magnification ratio adjustment
•Print off-center adjustment
•Void area adjustment
1) Hold and push the [MENU] key and the [OK] key, turn on the power.
("PCU DIAG MODE ***" is displayed.)
*
Do not touch the keys for about 8sec after releasing fingers from
the above keys.
2) Push the [MENU] key several times until "TEST PRINT" is displayed,
and push the [OK] key to enter the test print mode.
3) Make a print with "71" from each paper feed tray.
4) Push the [MENU] key several times until PAPER BUCKLE is
displayed.
Adjust the resist quantity so that paper is transported normally.
<Factory setup>
PAPER
45CPM
BUCKLE
35CPM
F. Option paper feed tray paper guide adjustment
This adjustment is performed in the following cases:
•When the option paper feed tray is installed.
•When the paper size detection fails.
1) Hold and push the [MENU] key and the [OK] key, turn on the power.
("PCU DIAG MODE ***" is displayed.)
*
Do not touch the keys for about 8sec after releasing fingers from
the above keys.
2) Push the [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed, and push the [OK] key.
3) "MAXIMUM SIZE" is displayed on the LCD.
Pull out the cassette, open the paper guide to the maximum, return
the cassette to the machine, and push the [OK] key.
4) "MINIMUM SIZE" is displayed on the LCD.
Pull out the cassette again from the machine, close the paper guide
to the minimum, return the cassette to the machine, and push the
[OK] key.
MFT
60
T1
70
T2
55
T3
55
T4
60
MFT
65
T1
75
T2
60
T3
60
T4
65
AR-P350 ADJUSTMENTS-5
G. Manual feed section
paper guide position adjustment
This adjustment is performed in the following cases:
•When the duplex unit with the manual feed unit is installed.
•When the manual feed tray paper size detection fails.
1) Hold and push the [MENU] key and the [OK] key, turn on the power.
("PCU DIAG MODE ***" is displayed.)
*
Do not touch the keys for about 8sec after releasing fingers from
the above keys.
" ON "
2) Push the [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed, and push [
] key to display "SIZE ADJUSTMENT B" and
push the [OK] key.
3) "MAXIMUM SIZE" is displayed on the LCD.
Check the value displayed with MAXIMUM SIZE. Use [
key to make the displayed value same as the MAX value specified on
the label (* Note).
4) "P1 SIZE" and a value are displayed. Use [
the displayed value same as the P1 value specified on the label
(* Note).
5) "P2 SIZE" and a value are displayed. Use [
the displayed value same as the P2 value specified on the label
(* Note).
6) "MINIMUM SIZE" and a value are displayed. Use [
make the displayed value same as the MIN value specified on the
label (* Note).
(*Note) Label attachment position
Label
] or [
]
] or [
] key to make
] or [
] key to make
] or [
] key to
Advertisement
Table of Contents
