Table of Contents
Advertisement
[8] MACHINE OPERATION
1. Function of each LED
READY
ON
Print job reception enable
Flash
OFF
Print job reception disable •Neither print data nor data under process are stored.
*
RIP:Raster In Processor. Develops the print command into pixel information.
2. Outline of each mode
The menu groups are classified into five groups and are selected consecutively by pressing the [MENU] key. If the [OK] key is pressed when the desired
menu screen is displayed, a message will appear to indicate the next required operation.
In addition, there is the service diag mode used for a serviceman.(with the scanner unit installed)
READY.
PRINT JOBS ON HOLD
SET OPERATIONS
CONDITIONS
CUSTOM SETTINGS
KEY OPERATION
PROGRAMS
DATA
•When RIP-completed print data are stored in memory. •When a trouble which can be canceled by the user
•When data are processed in the printer board
(during RIP).
Job status screen
The message "WARMING UP" will be displayed when the power is turned on
and a list of the current job plus reserved jobs or a list of completed jobs will
[MENU] key
be displayed on the job status screen. Examples of the various messages
which will be displayed are shown below.
(Display example)
WARMING UP.
READY.
FROM TRAY #
CHANGE THE TONER
CARTRIDGE.
PAPER JAM.
ADD PAPER.*
[ADD PAPER] of status display
*
When the status display shows [ADD PAPER], paper is required to
complete a job in progress. In this case, printing of the job will be
suspended until the required paper is added or another paper is
selected (see "Setting the paper size and type" ).
While a current job is suspended, the printer will print a reserved
job if paper is available from another source for that job but will not
print any other jobs.
Print hold
If the job retention function is used from your computer, print data will
[MENU] key
be stored in the printer as a hold job.
The job retention function can be used only if the printer is equipped
with a hard disk drive unit (AR-HD3).
Condition settings
[MENU] key
The printer condition settings are used for basic printer settings.
Custom settings
Custom settings are used to make settings based on use patterns.
[MENU] key
Key operator programs
These are settings used by key operators.
[MENU] key
AR-P350 MACHINE OPERATION-1
ERROR
occurred.
•When a trouble which requires service call occurred.
•No trouble
The printer is warming up.
The printer is ready to print.
The printer is currently printing.
Out of toner. Replace the toner
cartridge.
A misfeed has occurred.
Out of paper. Load paper.
Advertisement
Table of Contents
