Table of Contents
Advertisement
4) While rotating the MG roller, supply developer into the developer
cartridge evenly.B
Note: Before opening the developer seal, shake it 4 or 5 times.
5) Attach the top cover to the developer cartridge and install the
cartridge to the machine.
D. Setting related to fusing
1) Put down the right and the left levers of the fusing unit in the arrow
direction.
E. Paper setting
1) Pull out the first stage paper feed tray.
2) While pressing the paper holding plate, remove the fixing pin.
3) Put paper in the tray, and close the paper feed tray.
F. Automatic developer adjustment
1) Attach the cabinets which were removed.
2) Close the left door and the front door.
3) Insert the power plug into the power outlet.
4) While pressing the [MENU] key and the [OK] key, turn on the power
switch, and the machine will enter the diag mode.
5) On the operation menu, select "AUTOMATIC DV AD."
(LCD Display)
6) Press the [OK] key, and the automatic developer adjustment will be
performed.
During execution of the automatic developer adjustment, the data
(LED) blinks and the LCD indicates the toner sensor value.
7) After about 2 min, the adjustment value is stored in the machine.
Check that the mode was normally completed.
Remove the cause of the error, and execute the automatic developer
adjustment again.
8) Press the [BACK/C] key, and the machine returns to the normal
mode and enters the warm-p mode.
G. Print test
1) Press the [MENU] key to display "USER SETTING."
2) Press the [OK] key to select the menu.
3) Use [
list to check the print quality.
4) Press the [MENU] key again to return to the normal menu.
AR-P350 UNPACKING AND INSTALLATION-4
AUTOMATIC DV ADJ.
Normal end: The data LED goes off.
Abnormal end: The error LED lights up.
] and [
] keys to select List Print, and print the user setup
128
Advertisement
Table of Contents
