Table of Contents
Advertisement
464 Wheels and tyres
464
& W W ARNING
ARNING Risk of injury from tightening
wheel bolts and nuts
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip.
Only tighten wheel bolts or wheel nuts
#
when the vehicle is on the ground.
Be sure to observe the instructions and safety
#
notes on "Changing a wheel" (
For safety reasons, only use wheel bolts which
#
have been approved by Mercedes-Benz and
for the wheel in question.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
nger-tight.
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is nger-
#
tight.
Lower the vehicle (
page 464).
/
#
Lower ering t
Low
ing the v
he vehicle
R R eq equir uirements:
ements:
The new wheel has been tted (
R
* NO
NOTE TE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
page 455).
/
ped when the vehicle is lowered.
Start the engine. This adapts the vehicle
#
level.
Remove the jack from under the vehicle.
#
T T o low
o lower t
er the v
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
ehicle a er
a er a wheel c
a wheel change
hange
page 463).
/
he vehicle:
ehicle: place the ratchet onto
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
an initial maximum force of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the speci ed tightening torque of 150 Nm.
& W W ARNING
ARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
1
to
5
with
1
to
5
with
Advertisement
Table of Contents
