Table of Contents
Advertisement
242 Driving and parking
242
Combo 2 vehicle socket
Press the centre rear section of socket ap
#
1
and swing the socket ap forwards and
open.
The % indicator lamp
3
display
4
light up white.
%
When the vehicle is switched on (the õ
display is lit in the driver's display), socket ap
1
cannot be opened.
Press catch
#
cover 2.
%
Vehicles with a vehicle socket combo require
only connection
connector. Open only the upper part of socket
cover 2.
To charge at a mains socket, insert the mains
#
plug into the mains socket of the external
power source as far as it will go.
Insert the charging cable connector into vehi-
#
cle socket connection
wallbox/charging station is not equipped with
a charging cable, insert the plug of the vehi-
cle's charging cable into the wallbox/charging
station socket to the stop.
Make sure that the charging cable is not taut
and upper status
when inserted.
The # indicator lamp
display
high-voltage battery is charged, green.
7
to the right and fold up socket
6
for the charging cable
6
to the stop. If the
5
and lower status
4
ash orange and, as soon as the
%
When the charging sequence for the ambient
lighting is activated, the ambient lighting lights
up for approximately 30 seconds as with the
# indicator lamp
5
(
/
When the charging cable is connected to the vehi-
cle, the vehicle cannot be started or moved.
At the start of the charging process, the charge
level display is shown in the driver's display with a
charging prediction. The charging prediction
refers to the time at which the high-voltage bat-
tery will be fully charged.
%
Depending on the temperature, the fan and
battery cooling system may audibly switch on
during the charging process.
%
If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt-
age battery will be recharged automatically as
needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
page 169).
Advertisement
Table of Contents
