Elegoo Neptune3 Firmware Update Manual

Table of Contents

Download this manual

Neptune3 Firmware Update Guide

Firmware link:

https://github.com/NARUTOfzr/Neptune_3

Download method: As shown like the pic

 Files description：

 Preparation：

1. Format the TF card.

File system: FAT32 Allocation unit size: 4096 bit

2. Copy the two files into the root directory of the TF card.

 Screen firmware update：

As shown like pic 1, disassemble the back shell.

Pay attention to the plug location, insert the TF card.

Screen firmware

Motherboard firmware

ELEGOO Support：3dp@elegoo.com

Table of Contents

Do you have a question about the Neptune3 and is the answer not in the manual?

Page 1 Neptune3 Firmware Update Guide Firmware link: https://github.com/NARUTOfzr/Neptune_3 Download method: As shown like the pic  Files description： Screen firmware Motherboard firmware  Preparation： 1. Format the TF card. File system: FAT32 Allocation unit size: 4096 bit 2. Copy the two files into the root directory of the TF card.
Page 2 Insert the TF card into the machine. Reboot the power, wait until the firmware finish loading. The interface shows like pic3 when the firmware is loading. It will enter the interface like pic4 once the firmware is updated. ELEGOO Support：3dp@elegoo.com...
Page 3 Pic 3 Pic 4 ELEGOO Support：3dp@elegoo.com...
Page 4 At the same time, when you click 【Resume】 after the pause, the extruder will advance 6mm in the original printing position, so if you replace the filament, please do not insert it directly into the nozzle position. ELEGOO Support：3dp@elegoo.com...
Page 5 During printing, click 【stop】→【confirm】 or click 【confirm】 after printing is completed, the Z-offset value will be saved automatically. Screen firmware Update log： 20220711： Added 【Leveling Temperature Settings】 to 【Settings】 20220816： Added screen firmware version display.【Settings】→【About Machine】： You can view the motherboard firmware version and screen firmware version. ELEGOO Support：3dp@elegoo.com...