Elegoo Neptune First Use

Please refer to the included USB Drive for a Setup and Installation Instructional Video.

1. Power Supply Voltage Selection:

l Please adjust the voltage to match your local

voltage before first use, switch to 115V (for

operation 100-120V) , or to 230V (for operation 220-

240V).（The default factory voltage setting is

Voltage Requirements for some countries:

①CA/US/JP:100-120V

②DE/FR/UK/AU/RU/IT/ES: 220-240V

l The Y-axis slider plate is adjusted at the factory, but the machine's pulleys may be loose due to transportation. If

the printing platform is shaky or loose, you can use an open-end wrench to slowly unscrew the hexagonal isolation

column under the platform until the Y-axis slider plate slides smoothly without shaking!

l Similarly, you can adjust the hexagonal isolation column underneath the print head if it becomes wobble or loose.

There are also corresponding isolation columns for the pulleys on both sides of the gantry that can be adjusted.

Notice Before First Use

230V）

Table of Contents

Do you have a question about the Neptune and is the answer not in the manual?

Page 1 Notice Before First Use Please refer to the included USB Drive for a Setup and Installation Instructional Video. 1. Power Supply Voltage Selection: l Please adjust the voltage to match your local voltage before first use, switch to 115V (for operation 100-120V) , or to 230V (for operation 220- 240V).（The default factory voltage setting is 230V）...
Page 2 3. Auto-Leveling Procedure Note that the leveling sensor only detects the metal platform plate, for example, replacing the glass platform When first running the machine, the distance between the platform and the nozzle needs to be for leveling will not produce detection calibrated in the leveling mode, which is about the thickness of a piece of A4 paper .