Unwinder/Winder 100; Errordisplay - MUTOH ViperTX Extreme User Manual

To set display method to the operation panel when minor error occurred.
Menu
Error display
When loading fabrics, the printer will start initializing the fabric. Depending on the position of
the fabric and the use of a winding system, the setting should be changed.
Menu
Fabric
detection
AP-75340 - Revision 1.0
Parameter Description
Off Do not show the error
On Show the error
CANCEL Go back to the previous menu
Parameter Description
The fabric detection will be done automatically. As
Normal well the left, right as front side of the fabric will be
measured.
No automatic fabric detection will be done.
You should also set the fabric width and start position
Off
manually. Refer to
Use this setting when working with Mutoh's
Unwinder/Winder 100 and the fabric is loaded at
the right side.
TakeUpRoll
Only the left and right side of the fabric will be
measured.
The fabric can not be fed backwards.
Use this setting when working with Mutoh's
Unwinder/Winder 100 and the fabric is centre
loaded.
RollFeed
Only the left and right side of the fabric will be
measured.
CANCEL Go back to the previous menu
User's Guide ViperTX Extreme
Printer menu
and
5
101