2.1. INTRODUCTION
This chapter explains the features, part names and functions of the printer.
2.2. PART NAMES AND FUNCTIONS
Part names and functions are explained below.
2.2.1. Unwinder / Winder 100
Part names and functions are explained below.
No.
Name
1
Roll-Off System
2
Rear Tension system
3
PCB Box
4
Rail Assembly
5
Motorized roll unit
6
Roll unit
7
Roll-off foot switch
8
Front Tension System
9
Roll-Up System
10
Operation Panel
2. PRODUCT OVERVIEW
Function
This is the device that sets the media when using roll media and feeds it to
the printing position.
Adjust the tension of the media between the roll-off system and the media
feed slot.
Contains the boards to control the unwinder / winder 100.
Carries the roll units.
Supports the roll media.
Supports the roll media.
This switch is used to roll-up or roll-off roll media of the unwinder 100.
Adjust the tension of the media between the paper guide and the roll-up
system.
This is the device that collects the media when using roll media.
This panel is used to set operational conditions, and the status of the product.
11
Roll systems – Maintenance Manual
AP-74100, Rev. 2.0, 12/01/05