Sd Card Format - Racelogic Performance Box Touch V1 Quick Start Manual

Logging
Performance Box Touch V1 logs data via an SD card inserted into the SD cad Slot on the left-hand side of the unit.
Depending on the Logging Strategy you have selected in the
log continuously or when it detects movement.
You can manually override the configured logging
strategy by tapping on the
green to start or stop the logging.
The Record Icon will show when the unit is logging data
to the SD card.
If you have come to a stop, but the Record Icon is still
on, you must press the SD Card Icon to stop
the logging before you remove the SD card.
Sometimes, due to poor satellite visibility, for example in
a garage or close to a building, the box may start
recording even if the car is stationary. Always check the
Record Icon to make sure the box is not recording
before you eject the card.
IMPORTANT
The SD card should not be removed when
the Record Icon flashes red as it may cause you to
lose data.
Note: If the SD card is removed while the box is still
recording, you may need to repair it on a PC before you
can use it again.

SD Card Format

Performance Box Touch is supplied with an 8 GB SDHC card in a FAT32 file format, which is the only file format it
supports.
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V1/
SD Card Icon when it is
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V1/Quick_Start_Guide%3A_Lap_Timing_Mode_-
General Settings area, the unit will either
_Performance_Box_Touch_V1
6