ResMed Nox A1 How To Use Manual page 55

Troubleshooting
• For any issue not listed below, please contact your ResMed representative.
All impedances are black
Solution 1 Conduct an impedance test and wait for a few seconds
Solution 2 Check the M1, M2 electrode sites and the conductive paste of the reference ground electrode on the patient's forehead
There is no SpO signal on the screen
2
Solution 1 Check that the BDA number is the same as the one on the back of your Nonin 3150 oximeter
Solution 2 Press the grey activation button on the left top of the oximeter for two seconds
I can't connect to the Nox A1
Solution 1 Remove and re-insert again the battery into the Nox A1 and try again
EEG signals appear to be erroneous
Solution 1 Check the signal impedance. If they are red or black, check the placement of the electrodes
Solution 2 Check that the software filters are ON (right click on the signal > Filter > Filter presets)
My patient's details do not appear in the library
Solution 1 Right click on My Recordings and select Check for new Recordings
Solution 2 Right click on My Recordings and select Rescan Location
55