Transportation, Packaging, Storage; Accompanying Documents - HBS CPW 0604 Operating Manual

1.5

Transportation, Packaging, Storage

HBS delivers products in a specific transport package.
Save the undamaged packing. Ship and transport the device only in its original
packing.
Right before delivery, the CNC Production Welder is once again checked for proper
functioning and a control mark is attached. When receiving the delivery, check
everything for damages and completeness. If damages occurred during transportation
or components are missing, inform the manufacturer or the haulier immediately (see
page ii).
Proper functioning of the CNC Production Welder can only be checked before starting-
up by visual inspection (visible damage).
The following items are to be observed if the power unit is not to be put into operation
immediately after delivery.
– The CNC Production Welder must be stored in a secure place.
– The CNC Production Welder must be protected against humidity, dust, metallic dirt.
– Storage temperature: -5 °C to +50 °C
– Relative humidity:
If you resell the CNC Production Welder, please provide us with the name and
postal address of the new owner so that we can advise them of any changes to
the operating manual.
1.6

Accompanying Documents

In addition to this operating manual, you must observe the operating manual of the
components like welding head, power unit(s), stud feeding units etc., as well as
applicable accident prevention and safety instructions.
CPW 0604 BA CPW 0604 Issue 10.09.13 (From Software-Release 0.0.1.31)
0% to 50% at +40 °C
0% to 90% at +20 °C
1.5 Transportation, Packaging, Storage
1 General
15