Introduction For Buttons On Remote Controller - Gree GPA05AK Owner's Manual

Introduction for buttons on remote controller

Note:
● When power is connected(stand by condition), you can operate the air conditioner
through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending
signal icon "
ditioner gives out a beep sound, it means the signal has been sent.
● When unit is off, set temperature will be displayed on the remote controller (If the
light of indoor unit display is turned on, the corresponding icon will be displayed);
When unit is on, it will display the icon of the on-going function.
1
ON/OFF button
Press this button to turn unit on/off.
2
MODE button
Pressing this button once can select your required mode circularly as below (the
corresponding icon "
● When selecting cool mode, air conditioner will operate under cool mode. Then
press + or - button to adjust set temperature. Press FAN button to adjust fan speed.
● When selecting dry mode, air conditioner will operate at low fan speed under dry
mode. In dry mode, fan speed can't be adjusted.
● When selecting fan mode, air conditioner will operate in fan mode only. Then
press FAN button to adjust fan speed.
3
+ / - button
● Pressing + or - button once will increase or decrease set temperature by 1°F(°C).
Hold + or - button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.
● When setting Timer On or Timer Off, press + or - button to adjust the time. (See
TIMER Button for setting details)
4
FAN button
Pressing this button can select fan speed circularly as: AUTO, SPEED 1 (
SPEED 2 ( ), SPEED 3 (
" on the display of remote controller will blink once. If the air con-
" will be lit up after the mode is selected):
COOL
).
AUTO
DRY FAN
7
),