Clothing Care; Curtain And Soft Furnishing Care; Fluff Brush; Ironing Function - Silvercrest SDRB 1000 A1 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Note:
To release the first steam blast after heating the appli-
ance up, it can happen that you may need to press
the steam blast button 8 several times in succession.
The appliance is now ready for use.
Attention!
The steam brush can be used with all clothing items.
Caution is to be exercised with heat-sensitive materials
such as synthetics, polyamides or artificial silk. With
these materials you should first check at a concealed
part (inside seam) that the hot steam will not cause
any damage to the garment. Do not touch these ma-
terials directly with the hot sole of the iron 0. Use
only the steam blast.

Clothing care

• Suspend the crumpled garment from a coat hanger.
• With one hand pull the garment flat, then steam it
from top to bottom. The combination of steam and
clothes brush r will gently remove all creases.
• Use light pressure with the clothes brush r and
guide the appliance from top to bottom over the
garment. You can thereby press the steam blast
button 8 in short intervals.
Note:
You can repeatedly press the steam blast button 8
until the heating-up control lamp 5 glows or water
drips from the sole of the iron 0.
Then, wait until the heating-up control lamp 5 extin-
guishes before activating a further blast of steam.
• Should the heating-up control lamp 5 start to
glow during the process, release the steam
blast button 8 and wait a few seconds until the
heating-up control lamp 5 extinguishes.
Note:
Should you press the steam blast button 8 whilst
the heating-up control lamp 5 is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
• Leave the garment on the clothes hanger to cool
down before putting it on.

Curtain and soft furnishing care

• Creases and wrinkles can be removed from
draperies by hanging them over a pole.
• Then simply follow the directions given under
"Clothing care".
• Always carry out a test first at a concealed part.
• If you are using the appliance horizontally, every
now and then hold it upright so as to have the
maximum steam performance.

Fluff brush

• Threads, fluff and hairs can be easily removed
with the red fluff brush e by slowly brushing
over the garment with it from left to right.
• You can clean the fluff brush e by brushing with
it in the opposite direction (from right to left)
over, for example, a remnant of material.

Ironing function

• Dismantle the brush attachment w from the
appliance (see "Attaching/detaching the brush
attachment").
• Connect the appliance to a correctly installed
and earthed mains power socket.
• Adjust the temperature regulator 3 as per the
international point symbols (Care Label) or
the type of material. The heating-up control lamp
5 glows. As soon as the set temperature has
been reached, the heating-up control lamp 5
goes out .
Washing label
Chemical fibres,
- 8 -
Type of
Temperature
regulator 3
material
(low
e.g. viscose,
temperature)
polyester
••
(medium
Silk, Wool
temperature)
•••
(high
Cotton, Linen
temperature)

Advertisement

Table of Contents
loading

This manual is also suitable for:

77154

Table of Contents