Address Space - Siemens SIMATIC ET 200SP Equipment Manual

4.3

Address space

The module can be configured differently in STEP 7; see following table. Depending on the
configuration, additional/different addresses are assigned in the process image output/input.
Configuration options of RQ 4×120VDC-230VAC/5A NO MA ST
You can configure the module with STEP 7 (TIA Portal) or with a GSD file. If you configure the
module by means of a GSD file, the configurations are available under various short
designations/module names; see the table below. The following configurations are possible:
Table 4- 2 Configuration options with GSD file
Configuration
1 x 4-channel without value sta-
tus
1 x 4-channel with value status
Evaluating the value status
An additional byte is allocated in the input address space if you enable the value status for
the digital module. Bits 0 to 3 in this byte are assigned to a channel. They provide information
about the validity of the digital value.
Bit = 1: No fault is present on the channel.
Bit = 0: Channel is deactivated or there is a fault on the module.
If a fault occurs on a channel with this module, the value status for all channels is 0.
Digital output module RQ 4x120VDC-230VAC/5A NO MA ST (6ES7132-6MD00-0BB1)
Equipment Manual, , A5E36107692-AB
Short designation/module
name in the GSD file
RQ 4×120VDC-230VAC/5A NO
MA ST
RQ 4×120VDC-230VAC/5A NO
MA ST, QI
Configuration software, e.g. with STEP 7 (TIA Por-
tal)
Integrated in the GSD file
hardware catalog PROFINET IO
STEP 7, as of V13,
SP1
X
X
Parameters/address space
4.3 Address space
GSD file
PROFIBUS DP
X X
X -
17