Siemens SIMATIC ET 200SP Equipment Manual page 10

Properties
The module has the following technical properties:
• Digital output module with 4 floating relay outputs
• Supply voltage L+
• Output current 5 A (per output)
• Normally open contact (NO: normally open)
• Configurable diagnostics (per module)
• Configurable substitute values (per channel)
• 4 toggle/jog switches (jog, automatic or manual mode (MANUAL ON)) for controlling the
relay
• Suitable for solenoid valves, DC contactors, and indicator lights
The module supports the following functions:
• Firmware update
• I&M identification data
• Configuration in RUN
• PROFIenergy
• Value status
You can configure the module with STEP 7 (TIA Portal) and with a GSD file.
Note
When load voltage is present, the relays of the RQ 4x120VDC-230VAC/5A NO MA ST can also
be activated via a manual switch even when they are in a non-configured state.
When an output is set to manual control, the relay remains active during a firmware update.
Accessories
The following accessories must be ordered separately:
• Color identification labels
• Reference identification label
• Shield connector
See also
You can find additional information on the accessories in the system manual ET 200SP
distributed I/O system (http://support.automation.siemens.com/WW/view/en/58649293).
Digital output module RQ 4x120VDC-230VAC/5A NO MA ST (6ES7132-6MD00-0BB1)
Equipment Manual, , A5E36107692-AB
Product overview
2.1 Properties
9