AEG PROTECT C Series User Manual page 83

EN
Never connect additional loads to the UPS or switch on during a power failure, e.g. if
the UPS is operating in emergency mode!
As a rule, if there has never been an overload during normal operation, Battery mode
operation will also not have su ered an overload.
A ash of the LED fault in connection with a beep indicates a deactivating fault.
Follow the instructions in section .1.!
Finally, check the tightness of the emergency shut-o plug mounted jumper wire and
tighten the two outer screws of the contact securely (see also page , item. 6).
If you would like to use the emergency shutdown function, refer first to chapter .4 on
page 1 .
The built-in emergency shutdown voltage is only for UPS shutdown. This is done
electronically and does not correspond to an EMErGENC STOP device in
accordance with DIN EN ISO 13850.