Table of Contents
Advertisement
Kyle Form 4C Microprocessor-Based Recloser Control Programming Guide
The Form 4C control is equipped with a 24-hour notation
time clock that records the year, month, day, hour,
minute, and seconds of recorded events. The clock
begins operation upon connection to the control's ac
power or backup power supply.
The clock must be set at the time the control is installed
and reset whenever control power is disconnected.
When the control is first energized, the clock default
month and day are 1/1 and the year is 2001. The clock
must be set prior to programming or interrogation for the
recorded events to be logged to the proper day and
time.
The clock is used in conjunction with the event recorder
and load profile monitor to store events recorded in the
control. No security code is required to set the clock or
change clock settings.
To set, examine, or change clock settings, refer to
Access Codes 153 through 156.
1. Connect the ac supply and the control battery. Four
dashes (----) will appear on the LCD display to indi-
cate that the clock needs to be set.
2. From the keyboard, press DISPLAY ON. The Ready
(rdY) prompt appears indicating the control is ready
for programming.
The following example of a Display Test illustrates the use of the keyboard for interrogation. The same basic step-by-
step descriptive procedure is used for all keyboard interrogation and program change operations.
Each step of the procedure is numbered, the appropriate key to be pressed is illustrated, and the resulting keyboard
display is shown.
DISPLAY TEST
Step
No.
Touch Key
1.
2.
3.
CLEAR
6
SETTING THE CONTROL CLOCK
(Access Codes 153–156)
USING THE KEYBOARD
Display
Message
DISPLAY
ON
OFF
DISPLAY
EXAMINE PHASE
TEST
SCROLL CODE
CHANGE GROUND
0
OR
ESCAPE
To set the year:
1. Press the CODE key and the numbers 1-5-3 (for
access code 153). Then press ENTER.
2. Press the CHANGE key. Enter the four digits of the
current year. Press ENTER.
To set the date:
1. Press the SCROLL key to advance the control to
Access Code 154. Code 154 can also be entered
manually.
2. Press CHANGE. Enter four digits for the month (01
to 12) and day (01 to 31). Single-digit months and
days are preceded by a zero. Press ENTER.
To set hour and minute:
1. Press SCROLL to advance the control to Access
Code 155. Code 155 can also be entered manually.
2. Press CHANGE and enter four digits for the hour (01
to 24) and minute (01 to 59). Press ENTER.
To set seconds:
1. Press SCROLL to advance the control to Access
Code 156. Code 156 can also be entered manually.
2. Press CHANGE and enter two digits for the seconds
(01 to 59) and press ENTER.
Use the SCROLL key to review the new calendar and
clock settings. Press ESCAPE to return to the Ready
(rdY) prompt.
Access
Complex
Code
TCC
CODE
VALUE
CODE
VALUE
CODE
VALUE
Parameter
Value
Advertisement
Table of Contents
