Standard Access Codes And Parameters - Cooper Kyle Form 4C Programming Manual

Kyle Form 4C Microprocessor-Based Recloser Control Programming Guide

STANDARD ACCESS CODES AND PARAMETERS

Table 1 is a list of the standard access codes provided
on all Form 4C controls. A detailed list of program set-
tings, parameter descriptions, and keyboard access
codes appears in the Access Code Description section
of this manual. Access codes and parameter descrip-
tions can also be found on the control information label
located inside the cabinet door.
TABLE 1
Form 4C Control Standard Access Codes
ACCESS
CODE
PROGRAMMING
* 01 Minimum Trip - Phase and Ground
* 02 TCC1 - Phase and Ground
* 03 TCC2 - Phase and Ground
* 04 TCC1 Operations - Phase and Ground
* 05 Operations to Lockout - Phase and Ground
* 06 Reset Time
* 07 Reclose #1
* 08 Reclose #2
* 09 Reclose #3
* 10 CT Selection
* 11 Alternate Minimum Trip - Phase and Ground
12 Supervisory Close Reset Time
PHASE IDENTIFICATION
17 Bushings 1-2 Phase Identifier
18 Bushings 3-4 Phase Identifier
19 Bushings 5-6 Phase Identifier
FEATURE ON/OFF
20 Sequence Coordination
21 Target Reset After Successful Reclose
22 Operations Counter
23 Event Recorder
*24 Recloser Duty Monitor
25 Ground Trip Precedence
26 Supervisory Via Momentary Contact
TARGETS
30 Target Status/Reset
32 Target Counter - Ground
33 Target Counter - Phase 1-2
34 Target Counter - Phase 3-4
35 Target Counter - Phase 5-6
36 Target Counter - Sensitive Ground Fault
SEQUENCE POSITION
38 Sequence Position
14
PARAMETER
*Note: Programming of these access codes is required for
basic control operation.
ACCESS
CODE
OPERATIONS COUNTER
39 Operations Counter
METERING
40 Instantaneous Current - Ground
41 Instantaneous Current - Phase 1-2
42 Instantaneous Current - Phase 3-4
43 Instantaneous Current - Phase 5-6
44 Demand Current- Ground
45 Demand Current- Phase 1-2
46 Demand Current- Phase 3-4
47 Demand Current- Phase 5-6
48 Maximum Demand Current - Ground
49 Maximum Demand Current - Phase 1-2
50 Maximum Demand Current- Phase 3-4
51 Maximum Demand Current - Phase 5-6
57 Select Integration Intervals - Phase and
Ground
STATUS CODES
65 Accessory Status Code
67 Alternate Minimum Trip Status
MALFUNCTION CODES
66 Malfunction Status Code
TCC GROUP
* 70 TCC Group
LINE FREQUENCY
* 71 Line Frequency
FIRMWARE VERSION/CONTROL ID
72 CPU Firmware Version
76 Control Identification Number
77 CPU Firmware Revision Number
78 Display Board Firmware Version Number
CLOSE/RETRY
74 Close Retry Time
79 Number of Close Retry Attempts
PARAMETER