Downloading To A Data Reader - Cooper Kyle Form 4C Programming Manual

Kyle Form 4C Microprocessor-Based Recloser Control Programming Guide
DOWNLOADING TO A DATA
READER
The Data Reader (Figure 3) can be used with the Cooper
Power Systems Form 4C recloser control and CL-4, CL-4B,
CL-4C, and CL-5A regulator controls. Data gathered
from recloser and regulator controls is stored in the Data
Reader for later downloading into a personal computer
for system analysis. A single Data Reader can collect
and store data from 20 Form 4C controls, 100 regulator
controls, or any equivalent combination of readings from
the two types of controls. The Form 4C control is com-
patible with Data Reader Software DOS Version 4.0 or
above and with Windlows-based software, CCI version
1.02 and CCI version 3.01.
To operate the Data Reader:
1. Connect the Data Reader to the data port (Figure 2).
2. Press and hold the START DATA READING button.
All three LED lights will illuminate.
3. When the READING and READING COMPLETE
lights go out, release the START DATA READING
button. The BATTERY OK light will remain illuminated.
The READING light will illuminate and remain on
while the data reader obtains data from the control.
When the data has been recorded, the READING
COMPLETE light will illuminate.
4. Disconnect the Data Reader from the data port.
For additional information on the operation of the Data
Reader, refer to Service Information S225-30-1 Data
Reader Operating and Maintenance Instructions.
12
Figure 3.
Data Reader plugs into data port on the Form 4C
Control Panel.
901016KMA -F