GASLAND chef GH12SF Instruction Manual page 3

How To Use Your Gas Cooktop
The position of the corresponding gas burner is indicated on each control knob.
Gas burners
The burners are different in size and power. Choose the most appropriate one for
the diameter of the cookware being used.
The burner can be regulated with the corresponding control knob by using one of
the following settings:
OFF
High
Low
On those models fitted with a safety device
The knob must be pressed for about 6 seconds until the flame is lighted and
warmed up.
On those models fitted with an ignitor
The ignition button, identified by the symbol, must be pressed first, then the
corresponding knob is pushed and turned in the counter-clockwise direction to the
"High" setting.
Some models are equipped with an ignition switch incorporated into the control
knob. If this is the case, the ignitor is present, but not the switch(the
located near each knob).
To light a burner: Simply press the corresponding knob and turn it in the count-
er-clockwise direction to the high setting, keep press until the burner is lighted.
Caution: If the flame goes out accidentally, turn off the gas with the control knob
and try to light it again at least 1 minute later.
To turn off a burner: Turn the knob in the clockwise direction until it is stopped(it
should be on the "." setting).
8350 Patriot Blvd STE B, N. Charleston, SC 29418
www.gaslandchef.com
www.gaslandchef.com
(844) 538-7890
symbol is
support@gaslandchef.com
02