GASLAND chef GH12SF Instruction Manual page 11

Electrical Connection For Gas Cooktop
The cooktop fitted with a tripolar electrical supply cord which are designed to be
used alternating current .According to the indications on the rating plate located
under the cooktop. The earthing wire can be identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections
for the cooktop and oven should be independent, not only for safe purpose, but
also be convenient to remove them in the future.
Fit the supply cord with a standard plug for the demand rate indicated on the
rating plate or connect it directly to the electrical mains. In the latter case, a single
pole switch must be placed between the cooktop and the mains, with a minimum
opening between the contacts of 0.12inch in compliance with current safety
codes(the earthing wire must not be interrupted by the switch). The power supply
cord must be positioned so that it does not reach a temperature in excess of
122°F than room temperature at any point.
Before actual connection make sure that:
● The fuse and electrical system can withstand the load required by the cooktop;
● The electrical supply system is equipped with an efficient earth hook-up
according to the norms and regulations prescribed by law;
● The plug or switch are easily accessible.
8350 Patriot Blvd STE B, N. Charleston, SC 29418
www.gaslandchef.com
www.gaslandchef.com
(844) 538-7890 support@gaslandchef.com
10