GASLAND chef GH12SF Instruction Manual page 10

www.gaslandchef.com
09
Gas Connection For Gas Cooktop
The gas cooktop should be connected to the gas-supply by a registered installer.
During installation it is essential to fit an approved gas tap to isolate the supply
from the cooktop for the convenience of any subsequent removal or servicing.
Connect the cooktop to the gas mains or liquid gas, it must be carried out accord-
ing to the prescribed regulation in force, and only after it is ascertained that it is
adaptable to the type of gas to be used. If not, follow the instructions indicated in
the paragraph headed "Adapting To Different Types Of Gas ". In the case of
connection to liquid gas by tank, use pressure regulators that conform to the
regulation in force.
Important: For safety, for the correct regulation of gas use and long life of the
cooktop, ensure that the gas pressure conforms to the indications given in table 1
"Burners And Nozzle Specifications".
Connection to non-flexible tube(copper or steel)
Connection to the gas source must be done in such a way as to not create any
stress points at any part of the gas cooktop.
The cooktop is fitted with an adjustable "L" shape connector and a gasket to the
gas supply.
The connector should be dismounted and the gasket must be replaced.
The feeding connector of the gas to the cooktop is threaded 1/2 in gas tank.
Connection to flexible steel tube
The gas feed connector to the cooktop is threaded, 1/2 in connector for round gas
pipe. Only use pipes and sealing gaskets that conform to the standards currently
in force. The maximum length of the flexible pipes must not exceed 78.7 in. Once
the connection has been made, ensure that the flexible metal tube does not touch
any moving parts and not be crushed.
Check the seal
Once the cooktop was installed, make sure all the connections are properly
sealed, use a soapy soluion to test, never use flame.
8350 Patriot Blvd STE B, N. Charleston, SC 29418 (844) 538-7890 support@gaslandchef.com
www.gaslandchef.com