Ip Camera And Drawing; Ebl Graphics; Ebl Service - Panasonic 5054 Technical Manual

8

IP Camera and Drawing

In EBL Graphics it is possible to connect an IP camera and / or overview drawing to one or
several alarm points. The camera picture and the drawing will be sent to the display unit over
TCP/IP, by using EBL Service.
Note: For information on configuration data, contact the site system administrator.
Information
system overview drawing.
IP Camera
camera.
When a fire alarm occurs, the alarms are presented on the display unit in a list view. The
buttons will be shown when an IP camera or overview drawing is connected to the selected
alarm point.
1. Select an alarm in the alarm list.
2. Press the camera button or the information button to open a pop-up window.
3. Press anywhere on the window to close.
A new fire alarm has higher priority and will be displayed instead of the camera window or
the information window.
When all fire alarms in the system are reset, the pop-up window will be closed.
8.1

EBL Graphics

An EBL Graphics project needs to be created to connect the IP cameras to the alarm points.
1. Create a new project in EBL Graphics.
2. Add the IP cameras.
3. Save and close the project.
4. Copy the entire root folder to the C drive on the PC where EBL Service will be
installed.
8.2

EBL Service

EBL Service is an installation software and is dependent on Visual Studio 2015 run-time
components (both x64 and x86 versions). These can be requested to download from Brooks
engineering.
Note: The settings are saved in the "Panasonic Fire and Security" folder. The user account that
the EBL Service is running under must have at least read access to the folder where the EBL
Graphics configuration is located.
1. Install EBL Service.
– Visible when the selected alarm point in alarm state is connected to a
– Visible when the selected alarm point in alarm state is connected to an IP
19
Technical Manual
5054 Rev 0
For Firmware V2.0.x