User Definable Text Messages - Panasonic 5054 Technical Manual

6

User Definable Text Messages

The user definable text messages (alarm texts) are dependent on which unit type the display
unit is running in. Each alarm text (up to 40 alphanumeric characters) will be shown on the
second row. The texts are created and downloaded via EBLWin.
In the FDCIE, each alarm point (zone – address) and each zone can have an individual user
definable text message (alarm text) presented in the display unit by fire alarm; see the
Operation Manual for the system respectively.
The alarm texts shown in the FDCIE will also be sent to each display unit and shown in its
display.
Text messages for all or selected alarm points / zones can also be stored in each display
unit. These alarm texts will be shown instead of the alarm texts sent out from the FDCIE. Up
to 617 unique user definable texts can be programmed in the memory for each unit. If a word
or a whole sentence is reused in another "alarm text", more than 617 user definable texts
can be added to the memory.
The priority order of the alarm texts is as follows:
1. Point alarm text stored in the display unit.
2. Text sent out from the FDCIE
When alarm texts have been stored in all or in some display units, the unique alarm texts are
created in EBLWin and downloaded when the SSD in the FDCIE is downloaded.
Note: It is also possible to select which fire alarms that can be presented in the display unit
respectively, see chapter 5.10 Selective Alarm Presentation page 16
17
Technical Manual
5054 Rev 0
For Firmware V2.0.x