Panasonic 5054 Technical Manual page 29

7. Remove the insulating cover on the cables. The remaining strip of the shield should
be about 15 mm.
8. Bend the shield backwards over the insulating cover.
9. Clamp the cables on the ground bar plate. In order to avoid short circuit, ensure
secured connection, do not let the sprawl outside the cable fixing clamp.
Note: The ground bar plate is reversible to fit all cable thicknesses.
10. Connect the ground cable to the ground bar plate.
11. Reconnect the terminal block J5 to the P.C.B.
12. Reconnect the loudspeaker.
13. Assemble the front of the display unit with the two screws. Be careful not to pinch
any cables.
Note: The screws are mounted at a 45 degree angle.
14. Connect the cables to the appropriate terminal block in the FDCIE.
27
Technical Manual
5054 Rev 0
For Firmware V2.0.x