Disablement Message; Quiet Alarm; Fault; Buttons - Panasonic 5054 Technical Manual

The buzzer can be silenced but the alarm devices in the system cannot be silenced via 5054
"Silence buzzer".
If the buzzer is programmed in EBLWin as "Disabled", in this case it will never sound.
2.3

Disablement Message

Disablement
the display. When the disablement symbol is activated, the display back-light is turned on for
two minutes. The backlight will remain turned on with 10% screen brightness as long as there
are disablements in the system..
A fire alarm has higher priority and will be displayed instead of the disablement message.
2.4

Quiet Alarm

Quiet alarm can be shown in the display unit.
2.5

Fault

Fault in the system will be displayed as "General faults in system" on the display.
When the fault symbol is activated, the display back-light is turned on for two minutes. The
back-light will remain turned on with 10% screen brightness as long as faults exist in the
system.
The buzzer will sound (steady) as long as the fault is not acknowledged in the system.
A fire alarm has higher priority and will be displayed instead of the fault message.
2.6

Buttons

"Silence buzzer" is Always visible. The button "Silence buzzer" can be used to silence the
built-in buzzer. The buzzer will re-sound when a new fire alarm or fault occurs.
"Alarms queued" is Visible only when two or more fire alarms exist in the system. When
the button "Alarms queued" is visible, the user can scroll amongst the fire alarms. The first
alarm will automatically be shown again after 20 seconds, if no button is pressed during that
time.
in the system will be displayed as "General disablement in system" on
8
Technical Manual
5054 Rev 0
For Firmware V2.0.x