Trouble Shooting - Dexter Laundry 800ETC1-20030.1 Instruction Manual

Remove all dust and splinters from the ventilation
slits of the motor.
FR
Remove deposits from the cold water pump.
Change the cooling water.
ES
If necessary
PT
What
Changing the cutting disc.
IT
Cooling water pipe is damaged.
EL
If the cooling water pipe gets brittle, blocked or is damaged it can easily be replaced by another pipe of
the same type. Release the connections and the holders. Mount a new pipe with the same length. Fix it
(just like the old one).
PL
LUBRICATING
From time to time the guiding rails and the bearings of the motor need to be lubricated.
UA
TRANSPORT
• Before transport you should make sure, that the transport
and the plastic beam behind it is screwed well into the motor/cutting unit. The motor/cutting unit
RO
should not be allowed to move within the guiding rail.
• Before transport you should makse sure, that the plug is pulled and no water is found in the container.
EN • Never transport the device alone. The transport of device requires at least two people. The machine is
heavy. The best way is for the machine table is be separated from the basis.
• When transporting the device, it should always be lifted off from the ground. It should not be pushed
• If you do not transport the device in the working area, but at another place such as in a vehicle, it is
better to demount the device and transport it in the original packing material.
STORAGE
Store the equipment and its accessories out of the reach of children in a dark, dry place at above
freezing temperature.
The ideal storage temperature is between 5 and 30° C. Store the electric tool in its original packaging.

9. TROUBLE SHOOTING

Problem
1. Machine will not start • Power supply has been cut
2. Motor / cutting unit
can not or hardly be
moved
Possible reason
• Cord or plug is faulty
• Other electric error in the device
131
Remove the dust and splinters with a vacuum
cleaner or a brush.
Wipe the deposits away with a cloth.
Let the cooling water out of the water container,
clear water.
How?
Exchanging the cutting disc.
Replace the cooling water pipe.
(See below)
Remedy
• Test the power supply with a
different device
• Release the transport securing
• Grease the guiding rail or bearing