Trouble Shooting; Disposal And Recycling - Dexter Laundry 800ETC1-20035.1 Instruction Manual

9. TROUBLE SHOOTING

FR
Problem
1. Machine will not start
ES
PT
2. Motor / cutting unit
can not or hardly be
IT
moved
3. No water cooling
EL
PL
UA
RO
4. Machine suddenly
stops during use
EN
5. Low efficiency
cutting
6. Strong vibration,
unexpected noise,
strong smell

10. DISPOSAL AND RECYCLING

The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials
in this packaging can be reused or recycled.
The equipment and its accessories are made of various types of material, such as metal and plastic.
Defective components must be disposed of as special waste. Ask your dealer or your local council.
For EU countries only
Possible reason
• Power supply has been cut
• Cord or plug is faulty
• Other electric error in the device
• Twisted, bend or damaged cooling
water pipe
• Too little cooling water in container
•
Blocked pumping sieve
• Blocked pump
• Other fault or electric error in the
pump
• Power supply broken
• Cutting disc blocked
• Extension cord too long and / or
with too small diameter
• Power supply (e.g. generator) has
too low current
• Exceed maximum cutting depth
• Cutting disc unsuited or wrong
direction of rotation
• Unplug immediately! Cutting disc is
not being cooled, wrong mounted
or worn
• Unplug immediately! Other fault.
Never dispose of any electric power tools with your household refuse. To comply with
European Directive 2012/19/EU on waste electric and electronic equipment, and its
implementation in national laws, old electric power tools must be separated from other
waste and disposed of in an environment-friendly fashion, e.g. by taking them to a
recycling depot.
Remedy
• Test the power supply with a
different device
• Release the transport securing
• Grease the guiding rail or bearing
• Check the running of cooling water,
remove blocking if needed or
exchange the pipe
• Fill in cooling water to cover the
pump
• Clean the sieve
• Test the pump, clean remove
blocking
needed
• Test the power supply with a
different device
• Unplug immediately! Remove
blocking carefully, afterwards test
cutting disc
• Use extension cord with allowed
length and/or sufficient diameter.
• Connect the device to different
power supply
• Check the maximum cutting depth
• Test cutting disc for type of use,
condition and rotation direction
• Test cooling, cutting disc mounting
and direction of rotation, if needed
mount a new, suitable cutting disc
125