Dexter Laundry 800ETC1-20030.1 Instruction Manual page 125

g) Use the power tool, accessories, tool bits etc. in accordance with these instructions. Take into
account the working conditions and the work to be performed. Use of the power tool for
FR
operations di erent from those intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles
and grasping surfaces do not allow for safe handling and control of the tool in unexpected situations.
ES
5. Service
a) Have your power tool serviced by a quali ed repair person using only identical replacement
PT
parts. This will ensure that the safety of the power tool is maintained.
2.2 ADDITIONAL SAFETY INSTRUCTIONS
IT
Please read the operating instructions carefully and observe the information provided. It is important to
refer to these instructions in order to acquaint yourself with the equipment, its proper use and safety
information.
EL
• Set up the machine on a level, non-slip floor. Make sure that the machine does not wobble.
• Check that the voltage on the rating plate is the same as your supply voltage. Do not insert the power
PL plug in the power outlet until you have done so. Connect the power supply by a insulation
transformer or Residual Current Devices.
• Important: The cutting wheel will continue to rotate after the machine is switched o !
UA
• Never apply side pressure to the diamond cutting wheel in order to bring it to a halt.
• Important: The diamond cutting wheel must be cooled with water at all times.
• Always pull out the power plug before changing the cutting wheel.
RO
• Use only suitable diamond cutting wheels. Do not use cutting wheels with a maximum operating
wheel speed that is less than the rated spindle speed of the machine.
• If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his
EN
agent in order to avoid a safety hazard.
• Keep electric parts away from water and from persons in the working area.
• Never leave the machine unattended in rooms with children.
• Always pull out the power plug before examining the electric motor compartment system.
• Disorder in the work area can easily lead to accidents.
• Make sure that you stand squarely and solidly while working. Avoid abnormal body positions and
always keep your balance.
• If the cutting wheel becomes jammed by dust, chips, or workpiece fragments, or if you need to
interrupt your work, switch off the device and hold it motionless until the wheel has come to a
standstill. Never attempt to pull a still operating cutting disc out of a cut as this may cause a kickback.
Investigate and take corrective actions to eliminate the cause of the jam.
• The maximum permissible system impedance is 0.3535Ω at the interface point of the user's supply.
The user should determine in consultation with the supply authority, if necessary, that the equipment
is connected only to a supply of that impedance or less.
Any modi cation which could lead to a change in the original characteristics of the machine, for
example, the rotation speed or the maximum diameter of the cutting wheel, may be carried out only by
the manufacturer of the machine who con rm that the machine is still in conformity with safety
regulations.
WARNING ! Read all the safety information and instructions.
Failure to adhere to the safety information and instructions set
out below may result in electric shock, re and/or serious injury.
Keep all the safety information and instructions in a safe place for
future use.
125