Steam Out - Philips PICO BARISTO AMF Service Manual

PICO BARISTO
5.2

Steam Out

Before executing the steam out procedure, descale the machine taking care to remouve the Aqua-
clean filter from the appliance.
In case the filter on the machine is active (or it's in the machine) provide the consumer with a new
one.
Introduction
This document describes the Steam-Out procedure; the application is used in order to empty the
heater.
Steam Out
The machine enters in Steam-Out mode by holding pressed together:
• the B button and the L button;
while switching on the machine by main switch behind it.
Once entered the Steam Out mode the display shows the "STEAM
OUT" indication. Buttons can be released
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc sensor
must work correctly; if some errors occurs on Ntc during the steam-out,
the procedure can't continue and an error message is shown on the dis-
play.
IMPORTANT NOTE: to execute the Steam-Out procedure the DREGDRAW-
ER must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message is shown on
the display and the Steam-Out is interrupted.
The machine starts the Steam Out and in the display appears the indica-
tion "ON".
While the Steam Out runs the Electro valve is opened and water comes
out the Water/Steam pipe.
When the Steam Out is complete the message "COMPLETE" is shown on
the Display.The Electro valves automatically closes and the machine can
be switched off.
When the Steam-Out is complete the following parameters are reset to their default values:
Parameters
espresso_qty
espresso_lungo_qty
caffe_crema_qty
ristretto_qty
espresso_double_qty
cappuccino_qty
cappuccino_seconds
Introduction
Introduction
This document describes the Steam-Out procedure; the appli
Introduction
This document describes the Steam-Out procedure; the appli
Introduction
Introduction
This document describes the Steam-Out procedure; the appli
1 Steam Out
1 Steam Out
This document describes the Steam-Out procedure; the appli
The machine enters in Steam-Out mode by holding pressed to
This document describes the Steam-Out procedure; the appli
The machine enters in Steam-Out mode by holding pressed to
1 Steam Out • the B button and the L button;
• the B button and the L button;
while switching on the machine by main switch behind it .
The machine enters in Steam-Out mode by holding pressed to
1 Steam Out
while switching on the machine by main switch behind it .
1 Steam Out
• the B button and the L button;
Once entered the Steam Out mode the display shows the "STEAM
The machine enters in Steam-Out mode by holding pressed to
while switching on the machine by main switch behind it .
Once entered the Steam Out mode the display shows the "STEAM
OUT" indication. Buttons can be released
The machine enters in Steam-Out mode by holding pressed to
• the B button and the L button;
OUT" indication. Buttons can be released
• the B button and the L button;
while switching on the machine by main switch behind it .
Once entered the Steam Out mode the display shows the "STEAM
while switching on the machine by main switch behind it .
OUT" indication. Buttons can be released
Once entered the Steam Out mode the display shows the "STEAM
Once entered the Steam Out mode the display shows the "STEAM
OUT" indication. Buttons can be released
OUT" indication. Buttons can be released
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc
sensor must work correctly; if some errors occurs on Ntc during t
sensor must work correctly; if some errors occurs on Ntc during t
steam-out, the procedure can't continue and an error me
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc
steam-out, the procedure can't continue and an error me
shown on the display.
sensor must work correctly; if some errors occurs on Ntc during t
shown on the display.
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc
steam-out, the procedure can't continue and an error me
IMPORTANT NOTE: to execute the Steam-out procedure the Ntc
sensor must work correctly; if some errors occurs on Ntc during t
shown on the display.
sensor must work correctly; if some errors occurs on Ntc during t
steam-out, the procedure can't continue and an error me
steam-out, the procedure can't continue and an error me
shown on the display.
shown on the display.
IMPORTANT NOTE: to execute the Steam-Out procedure the
IMPORTANT NOTE: to execute the Steam-Out procedure the
DREGDRAWER must be in place and the DOOR must be closed.
DREGDRAWER must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message
IMPORTANT NOTE: to execute the Steam-Out procedure the
If these 2 conditions are not respected a warning message
on the display and the Steam-Out is interrupted.
DREGDRAWER must be in place and the DOOR must be closed.
on the display and the Steam-Out is interrupted.
IMPORTANT NOTE: to execute the Steam-Out procedure the
If these 2 conditions are not respected a warning message
IMPORTANT NOTE: to execute the Steam-Out procedure the
DREGDRAWER must be in place and the DOOR must be closed.
on the display and the Steam-Out is interrupted.
DREGDRAWER must be in place and the DOOR must be closed.
If these 2 conditions are not respected a warning message
If these 2 conditions are not respected a warning message
on the display and the Steam-Out is interrupted.
on the display and the Steam-Out is interrupted.
The machine starts the Steam Out and in the display appea
The machine starts the Steam Out and in the display appea
indication "ON".
indication "ON".
While the Steam Out runs the Electro valve is opened an
The machine starts the Steam Out and in the display appea
While the Steam Out runs the Electro valve is opened an
comes out the Water/Steam pipe.
indication "ON".
comes out the Water/Steam pipe.
The machine starts the Steam Out and in the display appea
While the Steam Out runs the Electro valve is opened an
The machine starts the Steam Out and in the display appea
indication "ON".
comes out the Water/Steam pipe.
indication "ON".
While the Steam Out runs the Electro valve is opened an
While the Steam Out runs the Electro valve is opened an
When the Steam Out is complete the message "COMPLETE" is comes out the Water/Steam pipe.
comes out the Water/Steam pipe.
When the Steam Out is complete the message "COMPLETE" is
shown on the Display.The Electro valves automatically clo
shown on the Display.The Electro valves automatically clo
machine can be switched o .
When the Steam Out is complete the message "COMPLETE" is
machine can be switched o .
shown on the Display.The Electro valves automatically clo
When the Steam Out is complete the message "COMPLETE" is
machine can be switched o .
When the Steam Out is complete the message "COMPLETE" is
shown on the Display.The Electro valves automatically clo
shown on the Display.The Electro valves automatically clo
machine can be switched o .
machine can be switched o .
When the Steam-Out is complete the following parameter
When the Steam-Out is complete the following parameter
D e f a u l t
Description
When the Steam-Out is complete the following parameter value
02 Nicola.La @philips
02 Nicola.La @philips
.com
revNum Author
When the Steam-Out is complete the following parameter
150 Dose (in impulse) of the "Espresso"
.com
When the Steam-Out is complete the following parameter
revNum Author
02 Nicola.La @philips
255 Dose (in impulse) of the "Espresso Lungo"
.com
revNum Author
02 Nicola.La @philips
02 Nicola.La @philips
350 .com Dose (in impulse) of the "Caffe Crema"
revNum Author
.com
revNum Author
130 Dose (in impulse) of the "Ristretto"
250 Dose (in impulse) of the "EspressoDouble"
185 Dose (in impulse) of the coffee cycle in the "Cappuccino"
Dose (in 1/10 seconds) of the milk cycle in the
340
"Cappuccino"
Steam-Out PicoBaristo
Steam-Out PicoBaristo
Steam-Out PicoBaristo
Steam-Out PicoBaristo
Steam-Out PicoBaristo
cation is used in order to empty the heater.
cation is used in order to empty the heater.
cation is used in order to empty the heater.
cation is used in order to empty the heater.
gether:
cation is used in order to empty the heater.
gether:
gether:
gether:
gether:
ssage is
ssage is
ssage is
ssage is
ssage is
is shown
is shown
is shown
is shown
is shown
rs the
rs the
d water
rs the
d water
rs the
d water
rs the
d water
d water
ses and the
ses and the
ses and the
ses and the
ses and the
s are reset to their default values:
s are reset to their default values:
s are reset to their default values:
Veri ed Approved
s are reset to their default values:
s are reset to their default values:
Veri ed Approved
Veri ed Approved
Veri ed Approved
Veri ed Approved
05 SERVICE MODE
FileName
FileName
20150804_SteamOut_PicoBaristo_v01.doc
20150804_SteamOut_PicoBaristo_v01.doc
FileName
20150804_SteamOut_PicoBaristo_v01.doc
FileName
FileName
20150804_SteamOut_PicoBaristo_v01.doc
20150804_SteamOut_PicoBaristo_v01.doc
he
he
he
he
he
07/08/2015
07/08/2015
SaveDate Pagina/pagine
SaveDate Pagina/pagine
07/08/2015
SaveDate Pagina/pagine
07/08/2015
07/08/2015
SaveDate Pagina/pagine
SaveDate Pagina/pagine
2/5
2/5
2/5
2/5
2/5
9/11