Introduction To Some Parameters Of Instrument Energy Meter; Flow Parameter - Microsensor MFE600H Series Operation Manual

7 Current output
8 Heat range setting
9 Cooling range setting
10 Pulse output method
11 Output pulse coefficient
12 Flow meter location
Heat meter to measure
13
water temperature
Cooling meter to measure
14
water temperature
15 Working pressure selection
16 Inlet PT check 1
17 Inlet PT check 2
18 Outlet PT check 1
19 Outlet PT check 2
20 Thermal resistance type
21 Simulation mode
22 Entry temperature setting
23 Export temperature setting
24 Test flow rate setting
25 Total heat preset
26 Total cooling capacity preset
27 Calibration mode
The meter needs to set the operating parameters correctly to make the meter run in the best state and
obtain higher measurement display accuracy and measurement output accuracy。

7 Introduction to some parameters of instrument energy meter

7.1 Flow parameter

7.1.1 Instrument working mode
The electromagnetic flowmeter heat meter has three working modes: Heat working mode, Cooling
working mode, heat and cooling working mode.
Flow output、Heat output
Choose
Cooling output、Cold and heat output
Setting
Setting
Flow frequency output Hz, Flow pulse
L, Flow pulse m³Heat pulse MJ, Heat
pulse GJ, Heat pulse KWh, Cooling
output MWh, Cooling pulse MJ,
Choose Cooling pulse GJ, Cooling pulse KWh,
Cold and heat output MWh, Heat and
cooling pulse MJ, Heat and cooling
pulse GJ, Heat and cooling pulse
KWh, Cooling and heat output MWh
Setting
Choose Flow inlet、Flow outlet
Setting 0～199.9
Setting 0～199.9
Choose 0.6MP/1.6MP
Access standard
Automatic correction
resistance 1
Access standard
Automatic correction
resistance 2
Access standard
Automatic correction
resistance 1
Access standard
Automatic correction
resistance 2
Choose Pt1000 Pt100
Choose Enable/Disable
Setting 0～199.9
Setting 0～199.9
Setting 0～19.999
Choose
Setting
Choose Enable/Disable
19