Undervoltage Alarm; Display Target Information On Live View; Set Transmission Parameters - HIKVISION DS-2DE2C200SCG-E User Manual

- Left click on a point on live image: the point is relocated to the center of the live image. With
no zooming in or out effect.
- Hold and drag the mouse to a lower right position to frame an area on the live: the framed
area is zoomed in and relocated to the center of the live image.
- Hold and drag the mouse to an upper left position to frame an area on the live: the framed
area is zoomed out and relocated to the center of the live image.
3. Click the button again to turn off the function.

4.1.14 Undervoltage Alarm

It is used to monitor the device voltage and warns you when the voltage is alarmingly low.
Note
This function is only supported by certain models.
When the device voltage is too low, a sign
to optimize the power supply, so as to avoid device failure.
The function is on by default.

4.1.15 Display Target Information on Live View

Go to Configuration → Local → Live View Parameters for settings.
Note
Related smart function should be configured and enabled in advance.
Display POS Information
POS information refers to the target features, such as target ID, etc. Supported POS information
types varies according to device models.

4.2 Set Transmission Parameters

The live view image may be displayed abnormally according to the network conditions. In different
network environments, you can adjust the transmission parameters to solve the problem.
Steps
1. Go to Configuration → Local .
2. Set the transmission parameters as required.
Protocol
TCP
Network Speed Dome User Manual
appears in the live view image. You are recommended
21