Supermicro H12SSG-AN6 User Manual page 61

ACS Enable
AER must be enabled for ACS to work. Options are Enabled, Disabled, and Auto.
Package Power Limit Control
Set to Auto to use the fused PPT or Manual to allow the user to set a customized PPT.
APBDIS
Use this setting to . Options include 0, 1, and Auto.
DF Cstates
Options include Disabled, Enabled, and Auto.
Preferred IO
Options include Manual and Auto.
Memory Configuration
Memory Clock
This setting allows you to select different memory clock speed. Options include Auto, 2667
MHz, 2933 MHz, and 3200 MHz.
Memory interleaving
This setting controls fabric level memory interleaving. Note that the channel, die and socket
have requirements on memory populations and it will be ignored if the memory doesn't
support the selected option. Options include Disabled and Auto.
Memory interleaving size
This setting controls the memory interleaving size. This determines the starting address
of the interleave (bit 8, 9, 10 or 11). OOptions include 256 Bytes, 512 Bytes, 1 KB, 2 KB,
4 KB, and Auto.
Chipset Interleaving
This setting controls interleave memory blocks across the DRAM chip for node 0. Options
include Disabled and Auto.
BankGroupSwap
This setting controls the Bank Group Swap. Options include Enabled, Disabled and Auto
DRAM Scrub Time
This setting provides a value that is the number of hours to scrub memory. Options include
Disabled, 1 hour, 4 hours, 8 hours, 16 hours, 24 hours, 48 hours, and Auto.
TSME
Use this setting to enable or disable TSME. Options include Disabled, Enabled, and Auto.
61
Chapter 4: BIOS